Hello all. I have been restoring my recently purchased 2001 XKR. Found a 2-pin connector dangling, with copper staple shorting the pins. Location: back of engine, left (US driver side), nearest back of cam cover. Very short cable. Connector looks grey. Wires are orange and black, but possible each has a green or blue strip (actually just a smear). Clueless where this goes. My best guess is use a cable to a thermal sensor, but am unable to verify.
Second, and minor. Windshield washer. Headlight washer works (too well, sprays all over the place). No fluid at windshield. I can hear the motor run. Nothing comes out the nozzles. Removed hose (brittle and will be replaced), and tried blowing into hose. Hoped I could send air/bubbles into washer fluid reservoir. Just blowing into a dead head. Can't find t-connection where hose source splits into left/right cowling, without success. Tried workshop manual (3000+ pages) but no good figures/picture. Can anyone help, perhaps a photo or diagram?